Chrysler/ Dodge/ Plymouth Slant Six 170/198/225 3.7L Six Cylinder Intake Manifold Equipped With EFI.
This intake is a baseline Aussiespeed AS0299 with fuel injection conversion. This intake is sold by Gill Welding & Fabrication who is the only Authorized Direct EFI Modified Aussiespeed Dealer.
 
You are purchasing the following:
(1) Gill Welding & Fabrication Direct Modified Aussiespeed AS0299 Intake Manifold.
(1) Custom Mounted Fuel Rail.
(1) Set of  (6) Injectors 5c3e-db (Verified Used)
(1) Set of (6) Injector Harnesses
(1) 1000 CFM Throttle Body (with TPS Sensor, but without IAC)
This system will support 220 (Turbo)-260 (N/A) HP with its current injectors. With larger injectors this system could support 450+ HP.
This system does not include:
Any components not listed above.
Gaskets
TPS Wiring Harness
IAC
IAC Wiring Harness
ECU
ECM
Fuel Delivery System (Tank to Regulator)
 
Fuel system quotes are avalbie by contacting us here.
 
This system may require modification to your factory or aftermarket equipment.
This system is for off road/race use only.
 
 
Specific details from Aussiespeed about the AS0299 are as follows:
"AS0299 SLANT 6 HIGH RISE 4 BARREL MANIFOLD
Aussiespeed has extended the Slant 6 4 barrel manifold line up with the new Slant 6 six cylinder short runner manifold the Aussiespeed Sl6 manifold has a runner length including the plenum from the cylinder head flange to the widest point of 30cm. has more advanced features than any slant 6 manifold available.
The AS0299 offers a new tall plenum and can be fitted with any of the Aussiespeed bolt in plenum pigs to change the way and rpm that the manifold performs. By bolting in an Aussiespeed plenum pig you can increase bottom end torque and still get the benefit of a taller plenum in the higher rpm range.
The new molded plenum floor helps to reintroduce any fuel that can drop out at lower rpm from the manifold floor due to fuel drop out.
The manifold has one x 3/8 npt vacuum take off on the rear of the manifold for brake vacuum and auto transmission fitting.
The manifold has nitrous bosses cast into the head flanges & the carburetor can be rotated 180 degrees to run the primaries closest to the inner guard." -Aussiespeed